After many folks expressed how much they liked our long lasting super composite nozzle for the smaller type 2 series, we have decided to launch a similar for the Type 1 size.
These are the larger version nozzle used for larger systems. It also replaces the ceramic nozzle tip on our large C1 nozzle assembly/holder.
Composite Carbide > Ceramic
Most brands of these large Type 1 series nozzles manufacture them in ceramic. If you blast with this a lot using very hard abrasive, it is best to upgrade to a carbide version. It is estimated to last hundreds of times longer than ceramic.
However, if you blast with softer abrasive or only blast occasionally, the ceramic is usually just fine.
Replaces Type 1, AKA C1
The type 1 nozzle tip is a large nozzle measuring 3.75″ long. It has a outside diameter (OD) of 1-1/8″ , tapered to 5/8″ O.D. This is the standard C1 size as well.
High Cost, But Lower Long-term Cost
Many folks want to upgrade to this longer lasting nozzle to reduce cost in the long run. Plus, it reduces the frequency of stopping in the middle of a blasting project to replace a worn ceramic version.
The Type 1 with the special durable carbide is quite expensive to manufacture. However, it is well worth it in the long run.
At the moment, we only manufacture these with an inner diameter (ID) of 1/8″. In the future we may offer a 3/16″ and 1/4″ size.
Please leave a comment below if you would prefer one of those size instead.
Where to Order the Type 1 Composite Carbide Nozzle Tip
At the moment, these are offered on Amazon. Please check it out by visiting the button below to see the listing and let me know if any questions.
Check out our Sandblasting Supplies
Gravity-Fed Sandblaster
Portable, Quick & Easy Setup
Unique Nozzle Holders & Hose Systems
Check out our Longer-Lasting Nozzle Tips
Select from ceramic or various carbides. Large C1 sizes & regular C2 sizes
HELLO, CHECKING TO SEE IF YOU HAVE THE LARGER COMPOSITE TIP WITH A 3/16 HOLE
Dave,
Thanks for checking. That was the next size we were thinking about making but wanted to check on how many folks were interested first.
Hi I am looking for a large Carbide nozzle with a tip hole of 1/16 or at least 3/32. Do you have something that fits with these spec?
@Bruno, not at the moment but will consider this size. However, we do supply the Type 1 with a 3/32″ with the ceramic material.
Need a type 1 tip, what is the smallest practical bore for 80grit glass bead.
Hello
From a re-joined member. Can anyone recommend how they go about reclaiming used blast media?
Thanks Jeff
how to buy?
i’m from the philippines